Home › Vehicle Interior › SEAT › CLIMATE CONTROL SEAT SWITCH

CLIMATE CONTROL SEAT SWITCH > INSPECTION

for Preparation Click here



1. INSPECT REFRESHING SEAT SWITCH



B356445E01


Text in Illustration 
*a
Component without harness connected
(Refreshing Seat Switch)
*b
Blower
*c
Heater
*d
Blower Max.
*e
Heater Max.
-
-
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH Side:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (BLLH) - 10 (SVSG)
    Switch off
    1.72 to 2.64 kΩ
    Switch on (Blower Min.)
    Switch on (Blower Max.)
    Below 510 Ω
    6 (SW) - 1 (RV)
    Switch off
    2.72 to 4.08 kΩ
    Switch on (Heater Min.)
    Switch on (Heater Max.)
    0.28 to 0.42 kΩ

    Standard Resistance:
    for RH Side:
    Tester Connection
    Switch Condition
    Specified Condition
    9 (BLRH) - 10 (SVSG)
    Switch off
    1.72 to 2.64 kΩ
    Switch on (Blower Min.)
    Switch on (Blower Max.)
    Below 51 Ω
    11 (SW) - 2 (RV)
    Switch off
    2.72 to 4.08 kΩ
    Switch on (Heater Min.)
    Switch on (Heater Max.)
    0.28 to 0.42 kΩ

    HINT:
    As the dial is being turned, the resistance changes gradually.

    If the result is not as specified, replace the refreshing seat switch.

  1. Apply battery voltage to the switch connector and check that the refreshing seat switch illuminates.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → 4 (ILL+)
    Battery negative (-) → 3 (ILL-)
    Illuminates

    If the result is not as specified, replace the refreshing seat switch.

  1. Apply battery voltage to the switch connector and check that the refreshing seat switch indicator illuminates.

    OK:
    Measurement Condition
    Switch Condition
    Specified Condition
    Battery positive (+) → 5 (IG)
    Battery negative (-) → 12 (E)
    Switch on
    Indicator illuminates

    If the result is not as specified, replace the refreshing seat switch.