Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR (for Front Side)

WASHER MOTOR (for Front Side) > INSPECTION

for Preparation Click here



1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
  1. Remove the washer jar.

  1. Disconnect the windshield washer motor and pump connector.

    HINT:
    Make sure that the windshield washer motor and pump is installed to the washer jar.

  1. Fill the washer jar with washer fluid.



    E197535
  1. Connect the positive (+) lead of the battery to terminal 1 of the windshield washer motor and pump and the negative (-) lead to terminal 2.

  1. Check that washer fluid flows from the washer jar.

    OK:
    Washer fluid flows from the washer jar.

    If the result is not as specified, replace the washer motor and pump assembly.