Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE HOOD COURTESY SWITCH

ENGINE HOOD COURTESY SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HOOD LOCK ASSEMBLY (ENGINE HOOD COURTESY SWITCH)


  1. Measure the resistance according to the value(s) in the table below.


    B240482E01

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Unlock position
    Below 1 Ω
    1 - 2
    Lock position
    10 kΩ or higher

    If the result is not as specified, replace the hood lock assembly.

    Text in Illustration 
    *a
    Unlock Position
    *b
    Lock Position
    *c
    Component without harness connected
    (Hood Lock Assembly (Engine Hood Courtesy Switch))
    -
    -