Home › Vehicle Exterior › DOOR / HATCH › HOOD

HOOD > DISASSEMBLY

for Preparation Click here



1. REMOVE HOOD TO RADIATOR SUPPORT SEAL


    B237102
  1. Using a clip remover, remove the 7 clips and hood to radiator support seal.

    NOTICE:
    If the clips are damaged or fall off, replace them with new clips.



2. REMOVE HOOD BULGE (w/ Hood Bulge)


    B237280
  1. Remove the 4 nuts.



    B237281
  1. Detach the 3 clips from the back side of the hood panel.



    B354468
  1. Using moulding remover, detach the 2 guides to remove the hood bulge together with the hood air intake guide as shown in the illustration.



3. REMOVE HOOD AIR INTAKE GUIDE (w/ Hood Bulge)


    B237530
  1. Detach the 4 claws to remove the hood air intake guide.



4. REMOVE NO. 1 HOOD BULGE PROTECTOR (w/ Hood Bulge)


    B242453
  1. Remove the 2 No. 1 hood bulge protectors.



5. REMOVE NO. 2 HOOD BULGE PROTECTOR (w/ Hood Bulge)


    B242454
  1. Remove the 2 No. 2 hood bulge protectors.



6. REMOVE NO. 3 HOOD BULGE PROTECTOR (w/ Hood Bulge)


    B242455
  1. Remove the No. 3 hood bulge protector.



7. REMOVE WASHER NOZZLE SUB-ASSEMBLY


    E199009E01
  1. Using a screwdriver, detach the 2 claws and disconnect the washer nozzle sub-assembly as shown in the illustration.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Be careful not to damage the windshield.



    E201314
  1. Remove the washer nozzle sub-assembly from the washer hose.

    NOTICE:
    Washer nozzles cannot be reused.



8. DISCONNECT WASHER HOSE ASSEMBLY


    B237104
  1. Detach the 5 clamps to disconnect the washer hose assembly.



9. REMOVE HOOD SUPPORT ASSEMBLY LH

NOTICE:
  1. Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing the vehicle.
  2. Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.
  3. In order to prevent the piston rod from deforming, do not apply any horizontal load to the door stay.



    B237109E01
  1. Using a screwdriver, remove the 2 stop rings as shown in the illustration, and then remove the hood support.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Remove the hood support assembly while supporting the hood panel with one hand.

    HINT:
    Tape the screwdriver tip before use.



10. REMOVE HOOD SUPPORT ASSEMBLY RH

HINT:
Use the same procedure for both the RH and LH sides.