CYLINDER BLOCK > REPLACEMENT |
| 1. REPLACE STRAIGHT PIN |

| *A | Front Side | *B | Rear Side |
| *C | Upper Side | *D | Lower Side |
Remove the straight pins.
Using a plastic-faced hammer, tap in new straight pins to the cylinder block.
| Item | Specified Condition |
| Pin A | 22.5 to 23.5 mm (0.886 to 0.925 in.) |
| Pin B | 10.5 to 11.5 mm (0.413 to 0.453 in.) |
| Pin C | 8.5 to 9.5 mm (0.335 to 0.374 in.) |
| Pin D | 5.5 to 6.5 mm (0.217 to 0.256 in.) |
| 2. REPLACE CYLINDER BLOCK TIGHT PLUG |

| *A | LH Side | *B | RH Side |
| *1 | Standard Depth | - | - |
Remove the tight plugs.
Apply adhesive around new tight plugs.
Using SST and a hammer, tap in the tight plugs to the standard depth.