Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER

RADIO RECEIVER > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 RADIO BRACKET
  1. Install the No. 2 radio bracket with the 3 screws.

    Torque:
    2.5 N*m{ 25 kgf*cm , 22 in.*lbf }



2. INSTALL NO. 1 RADIO BRACKET
  1. Install the No. 1 radio bracket with the 3 screws.

    Torque:
    2.5 N*m{ 25 kgf*cm , 22 in.*lbf }



3. INSTALL HAZARD SWITCH WIRE
  1. Connect the connector.

  1. Attach the 2 clamps to install the hazard switch wire.



4. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKETS
  1. Connect each connector.



    B352863
  1. Insert the radio and display receiver assembly with brackets to attach the 6 claws on its backside.

    NOTICE:
    When inserting the radio and display receiver assembly with brackets, do not press its knobs on it.

  1. Install the radio and display receiver assembly with brackets with the 4 bolts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }



5. INSTALL HEATER CONTROL ASSEMBLY


    E202383
  1. Attach the 4 clips to install the heater control assembly.



6. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 2 instrument cluster finish panel garnish.



7. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 1 instrument cluster finish panel garnish.