Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER

RADIO RECEIVER > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Put protective tape around the No. 1 instrument cluster finish panel garnish.



  1. Grip the No. 1 instrument cluster finish panel garnish and pull it diagonally upward toward the rear to detach the 5 clips and remove the No. 1 instrument cluster finish panel garnish.


    B353454E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



2. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Open the instrument cluster finish panel lid.

  1. Put protective tape around the No. 2 instrument cluster finish panel garnish.



  1. Grip the No. 2 instrument cluster finish panel garnish and pull it diagonally upward toward the rear to detach the 5 clips and remove the No. 2 instrument cluster finish panel garnish.


    B246534E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



3. REMOVE HEATER CONTROL ASSEMBLY


    E202382
  1. Detach the 4 clips and remove the heater control assembly.



4. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKETS


    B296608
  1. Remove the 4 bolts.



    B352862
  1. Pull the radio and display receiver assembly with brackets as shown in the illustration to detach the 6 claws on the backside of the radio and display receiver assembly with brackets.



    B352326
  1. Disconnect each connector to remove the radio and display receiver assembly with brackets.



5. REMOVE HAZARD SWITCH WIRE


    B352327
  1. Detach the 2 clamps.

  1. Disconnect the connector to remove the hazard switch wire.



6. REMOVE NO. 1 RADIO BRACKET


    B352328
  1. Remove the 3 screws and No. 1 radio bracket.



7. REMOVE NO. 2 RADIO BRACKET


    B352329
  1. Remove the 3 screws and No. 2 radio bracket.