Home › Audio / Visual / Telematics › AUDIO / VIDEO › INSTRUMENT PANEL SPEAKER

INSTRUMENT PANEL SPEAKER > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL NO. 1 SPEAKER MOUNTING BRACKET (for 8 Speakers)
  1. Install the No. 1 speaker mounting bracket with the 2 bolts.

    Torque:
    2.5 N*m{ 25 kgf*cm , 22 in.*lbf }



2. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY
  1. Connect the connector.



  1. Align the positioning pins of the front No. 2 speaker assembly with the instrument panel sub-assembly to temporarily install the front No. 2 speaker assembly.


    B352332E01


    Text in Illustration 
    *A
    for 9 Speakers
    *B
    for 8 Speakers

  1. Install the front No. 2 speaker assembly with the 2 screws.

    Torque:
    2.5 N*m{ 25 kgf*cm , 22 in.*lbf }

    NOTICE:
    1. Do not touch the cone of the front No. 2 speaker assembly.
    2. When installing the front No. 2 speaker assembly to the instrument panel sub-assembly, be careful that the wires do not get caught between the parts.



3. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY
  1. Attach the 2 clips, 4 claws and 3 guides to install the No. 1 instrument panel speaker panel sub-assembly.



4. INSTALL FRONT PILLAR GARNISH LH
  1. Remove the protective cover.

  1. Attach the 2 guides and clip to install the front pillar garnish LH.

  1. Install the bolt.

  1. Attach the 2 claws to install the No. 1 front pillar garnish cover LH.