Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK STOP LIGHT CONTROL RELAY
  1. Remove the stop light control relay from the engine room relay block.



    A087121E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2
    Below 1 Ω
    Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage to terminal 2
    10 kΩ or higher
    3 - 5
    Battery positive (+) voltage not applied to terminal 1 and battery negative (-) voltage applied to terminal 2
    10 kΩ or higher
    Battery positive (+) voltage applied to terminal 1 and battery negative (-) voltage to terminal 2
    Below 1 Ω

    If the result is not as specified, replace the relay.

  1. Install the stop light control relay.