TRANSFER OIL > ON-VEHICLE INSPECTION |
| 1. CHECK TRANSFER OIL |
![]() |
Remove the filler plug and gasket.
![]() |
Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.
If the result is not as specified, add transfer oil.
| *a | 0 to 5 mm |
When the oil level is too low, check for oil leaks.
Install a new gasket to the filler plug and then tighten the plug.
| 2. ADD TRANSFER OIL |
Remove the filler plug and gasket.
Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.
Wait approximately 5 minutes and check that the oil level has not changed.
Install a new gasket to the filler plug and then tighten the plug.