AIR SWITCHING VALVE (for Bank 1) > INSPECTION |
| 1. INSPECT NO. 1 EMISSION CONTROL VALVE SET |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 5 | 20°C (68°F) | 4.5 to 5.5 Ω |
| 1 - Body ground | Always | 1 MΩ or higher |
| 5 - Body ground |
| *a | Component without harness connected (No. 1 Emission Control Valve Set) |
![]() |
Check the operation of the No. 1 emission control valve set.
Check that air does not flow from port A to port B.
| *1 | Air |
| *2 | Port A |
| *3 | Port B |
![]() |
Apply battery voltage across terminals 1 and 5.
Check that air flows from port A to port B.
| *1 | Air |
| *2 | Port A |
| *3 | Port B |