Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH

POWER STEERING OIL PRESSURE SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT POWER STEERING OIL PRESSURE SWITCH
  1. Check the oil pressure switch.

    1. Connect the Techstream to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the Techstream on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / Power Steering Switch.

    5. Start the engine.

    6. Read the value displayed on the Techstream.

      OK:
      Condition
      Specified Condition
      Power steering operating
      ON
      Power steering not operating
      OFF

      If the result is not as specified, check the wire harness and connector. If the wire harness and connector are normal, replace the power steering oil pressure switch.