REAR BUMPER (w/ Intuitive Parking Assist System) > REMOVAL |
| 1. REMOVE JACK BOX HOLE COVER |
![]() |
Put protective around the jack box hole cover.
Using a moulding remover, Detach the 2 claws and 2 guides and remove the jack box hole cover.
| *1 | Protective Tape |
| *2 | Moulding Remover |
| 2. REMOVE REAR QUARTER PANEL MUDGUARD LH |
![]() |
Remove the 4 clips, 4 screws and rear quarter panel mudguard LH.
| 3. REMOVE REAR QUARTER PANEL MUDGUARD RH |
| 4. REMOVE REAR BUMPER COVER |
Remove the 2 bolts and 2 screws.

Put protective tape around the rear bumper cover.
Remove the 2 screws and 6 bolts.
Detach the 18 claws to remove the rear bumper cover.

| *1 | Protective Tape | - | - |
Disconnect the connector.
| 5. REMOVE REAR BUMPER ENERGY ABSORBER |
![]() |
Remove the rear bumper energy absorber.
| 6. REMOVE REAR BUMPER BAR REINFORCEMENT LH |
![]() |
Remove the 2 bolts and rear bumper bar reinforcement LH.
| 7. REMOVE REAR BUMPER BAR REINFORCEMENT RH |
| 8. REMOVE REAR BUMPER SIDE SUPPORT LH |
![]() |
Remove the 3 screws.
Detach the 5 claws to remove the rear bumper side support LH.
| 9. REMOVE REAR BUMPER SIDE SUPPORT RH |
| 10. REMOVE REAR COMBINATION LIGHT LENS AND BODY LH |
![]() |
Remove the cover.
Remove the 2 nuts.
Detach the 2 clips and 3 guides to remove the rear combination light lens and body LH.
Disconnect the connector.
| 11. REMOVE REAR COMBINATION LIGHT LENS AND BODY RH |
| 12. REMOVE REAR BUMPER UPPER RETAINER LH |
![]() |
Detach the 2 clips to remove the rear bumper upper retainer LH.
| 13. REMOVE REAR BUMPER UPPER RETAINER RH |
| 14. REMOVE PINTLE HOOK SUPPORT TUBE SUB-ASSEMBLY (w/ Pintle Hook) |
![]() |
Remove the 6 bolts and pintle hook support tube sub-assembly.