Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING

ROOF DRIP SIDE FINISH MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE ROOF RAIL ASSEMBLY LH (w/ Roof Rack)
  1. Remove the roof rail (Click here).



2. REMOVE FRONT ROOF DRIP SIDE MOULDING COVER LH (w/o Roof Rack)


B239342E01

HINT:
Use the same procedure to remove the front roof drip side moulding cover on the other side.

  1. Put protective tape around the front roof drip side moulding cover.
    Text in Illustration 
    *1
    Protective Tape

  1. Detach the 2 claws and remove the front roof drip side moulding cover.



3. REMOVE ROOF RACK BRACKET (w/o Roof Rack)


B239343

HINT:
Use the same procedure to remove the roof rack bracket on the other side.

  1. Remove the 2 bolts and roof rack bracket.



4. REMOVE ROOF DRIP SIDE FINISH MOULDING LH


B239344E01
  1. Put protective tape around the roof drip side finish moulding.
    Text in Illustration 
    *1
    Protective Tape

  1. Detach the clip and remove the roof drip side finish moulding.

    NOTICE:
    1. When removing the rear roof drip side finish moulding, be careful not to damage the roof drip side finish moulding clip.
    2. If the roof drip side finish moulding clip is damaged or becomes detached from the vehicle, replace it with a new one.



5. REMOVE CENTER ROOF DRIP SIDE FINISH MOULDING LH


B239345E01
  1. Put protective tape around the center roof drip side finish moulding.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the center roof drip side finish moulding.



6. REMOVE ROOF DRIP SIDE FINISH MOULDING LH


B239346E01
  1. Put protective tape around the roof drip side finish moulding.
    Text in Illustration 
    *1
    Protective Tape

  1. Detach the clip and remove the roof drip side finish moulding.

    NOTICE:
    1. When removing the roof drip side finish moulding, be careful not to damage the roof drip side finish moulding clip.
    2. If the roof drip side finish moulding clip is damaged or becomes detached from the vehicle, replace it with a new one.