RELAY (for Window Defogger) > ON-VEHICLE INSPECTION |
| 1. REMOVE DEFOGGER RELAY (DEF) |
![]() |
Remove the defogger relay from the engine room relay block.
| *1 | Defogger relay |
| 2. INSPECT DEFOGGER RELAY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Battery voltage is not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
| 3. INSTALL DEFOGGER RELAY |
Install the defogger relay to the engine room relay block.