Home › Vehicle Exterior › WINDOW / GLASS › RELAY (for Windshield Deicer)

RELAY (for Windshield Deicer) > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE DEICER RELAY (DEICER)


    B242837E01
  1. Remove the deicer relay from the engine room relay block.
    Text in Illustration 
    *1
    Deicer Relay



2. INSPECT DEICER RELAY


B060778E76
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the deicer relay.



3. INSTALL DEICER RELAY
  1. Install the deicer relay to the engine room relay block.