Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE (for Front Side)

WASHER NOZZLE (for Front Side) > INSTALLATION

for Preparation Click here



1. INSTALL WASHER NOZZLE SUB-ASSEMBLY
  1. Connect a new washer nozzle sub-assembly to the washer hose.



    E199010
  1. Attach the 2 claws to install the washer nozzle sub-assembly.



2. INSPECT WASHER NOZZLE SUB-ASSEMBLY


  1. With the engine running, check the position that the washer fluid hits the windshield.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.



    E199007E01


    Text in Illustration 
    *1
    Ceramic Line
    -
    -
    *a
    Upper Limit
    *b
    Standard
    *c
    Lower Limit
    -
    -
    V100155
    Washer Fluid Spray Area
    -
    -

    Standard:

    Area
    Measurement
    Area
    Measurement
    A
    254.5 mm (10.0 in.)
    B
    150 mm (5.91 in.)
    C
    127.6 mm (5.02 in.)
    -
    -

    If the result is not as specified, replace the malfunctioning washer nozzle sub-assembly.



3. ADJUST WASHER NOZZLE SUB-ASSEMBLY


  1. Select a washer nozzle so that the washer fluid spray area is as specified in On-vehicle Inspection. Replace the washer nozzle with the selected one.


    E179763E04


    Text in Illustration 
    *1
    Available Washer Nozzles
    *2
    Washer Fluid Spray Angle
    *3
    Part Number
    -
    -