REAR WIPER RUBBER > REPLACEMENT |
| 1. REMOVE REAR WIPER BLADE |
![]() |
Apply protective tape to the areas shown in the illustration.
| *1 | Protective Tape |
Turn the ignition switch to ON.
Turn the rear wiper switch on.
![]() |
Turn the ignition switch off when the wiper arm stops at the position shown in the illustration.
| Area | Measurement |
| A | Approximately 57° |
| B | Approximately 353 mm (13.90 in.) |
![]() |
Raise the rear wiper arm.
| *1 | Protective Tape |
![]() |
Raise the wiper blade to the position where the claw detaches with a click sound as shown in the illustration.
![]() |
Pull the wiper blade straight toward the left side of the vehicle to remove it from the wiper arm.
| 2. REMOVE REAR WIPER RUBBER |
![]() |
Lift and pull the end of the wiper rubber protrusion from the blade stopper as shown in the illustration.
| *1 | Stopper (Rear End of Blade) |
| *a | Lightly Push (Grip) |
| *b | Lift |
| *c | Pull |
Remove the rear wiper rubber backing plates.
| 3. INSTALL REAR WIPER RUBBER |
![]() |
Install the rear wiper rubber backing plates as shown in the illustration.
| *1 | Rear Wiper Rubber Backing Plate |
| *2 | Rear Wiper Rubber |
| *3 | Curve |
Insert the wiper rubber into the front end of the wiper blade and slide it towards the rear end through the second claw.
![]() |
After pushing the wiper rubber through the rear end claw, allow it to protrude past the rear end stopper.
| *1 | Second Claw |
| *2 | Rear End Claw |
| *3 | Rear End Stopper |
![]() |
Slide the wiper rubber through the front end claw.
| *1 | Front End Claw |
| 4. INSTALL REAR WIPER BLADE |
![]() |
Push the wiper blade straight toward the right side of the vehicle to install it to the wiper arm.
![]() |
Attach the claw to install the rear wiper blade as shown in the illustration.