ROOM LIGHT (for Rear) > REMOVAL |
| 1. REMOVE NO. 1 ROOM LIGHT ASSEMBLY |
![]() |
Using a screwdriver, detach the 4 claws and remove the No. 1 room light lens.
| *1 | Protective Tape |
![]() |
Using a screwdriver, detach the 2 claws and 2 guides and remove the 2 No. 1 room light covers.
| *1 | Protective Tape |
![]() |
Using a screwdriver, detach the 4 claws and disconnect the No. 1 room light assembly as shown in the illustration.
| *1 | Protective Tape |
![]() |
Using a screwdriver, detach the 4 claws and disconnect the room light switch base from the No. 1 room light assembly.