Home › Drivetrain · AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL LOCK POSITION SWITCH

REAR DIFFERENTIAL LOCK POSITION SWITCH > INSPECTION

for Preparation Click here



1. INSPECT REAR DIFFERENTIAL LOCK POSITION SWITCH


    C163511E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (GND) - 2 (+B)
    Pushed
    Below 1 Ω
    Released
    100 kΩ or higher

    Text in Illustration 
    *a
    Component without harness connected
    (Rear Differential Lock Position Switch)
    *b
    Pushed
    *c
    Released
    1. If the result is not as specified, replace the rear differential lock position switch.