Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY
  1. Attach the 2 claws to install the hazard warning signal switch assembly.

  1. Connect the connector.



2. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKETS (for Radio and Display Type)
  1. Connect each connector.



    B352863
  1. Insert the radio and display receiver assembly with brackets to attach the 6 claws on its backside.

    NOTICE:
    When inserting the radio and display receiver assembly with brackets, do not press its knobs on it.

  1. Install the radio and display receiver assembly with brackets with the 4 bolts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }



3. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKETS (for Navigation Receiver Type)
  1. Connect each connector.



    B352863
  1. Insert the navigation receiver assembly with brackets to attach the 6 claws on its backside.

    NOTICE:
    When inserting the navigation receiver assembly with brackets, do not press its knobs on it.

  1. Install the navigation receiver assembly with brackets with the 4 bolts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }



4. INSTALL HEATER CONTROL ASSEMBLY


    E202383
  1. Attach the 4 clips to install the heater control assembly.



5. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 1 instrument cluster finish panel garnish.



6. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 2 instrument cluster finish panel garnish.