Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    E107908E12
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 (B1) - 1 (E)
    Hazard warning signal switch off
    10 kΩ or higher
    Hazard warning signal switch on
    Below 1 Ω

  1. Apply battery voltage to the connector and check the LED illumination condition.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 3 (ILL+)
    Battery negative (-) → Terminal 2 (ILL-)
    LED illuminates

    If the result is not as specified, there may be a malfunction in the hazard warning signal switch.
    Text in Illustration 
    *a
    Component without harness connected
    (Hazard Warning Signal Switch Assembly)