Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Put protective tape around the No. 1 instrument cluster finish panel garnish.



  1. Grip the No. 1 instrument cluster finish panel garnish and pull it diagonally upward toward the rear to detach the 5 clips and remove the No. 1 instrument cluster finish panel garnish.


    B353454E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



2. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Open the instrument cluster finish panel lid.

  1. Put protective tape around the No. 2 instrument cluster finish panel garnish.



  1. Grip the No. 2 instrument cluster finish panel garnish and pull it diagonally upward toward the rear to detach the 5 clips and remove the No. 2 instrument cluster finish panel garnish.


    B246534E01


    Text in Illustration 
    *1
    Protective Tape
    -
    -



3. REMOVE HEATER CONTROL ASSEMBLY


    E202382
  1. Detach the 4 clips and remove the heater control assembly.



4. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKETS (for Radio and Display Type)


    B296608
  1. Remove the 4 bolts.



    B352862
  1. Pull the radio and display receiver assembly with brackets as shown in the illustration to detach the 6 claws on the backside of the radio and display receiver assembly with brackets.



    B352326
  1. Disconnect each connector to remove the radio and display receiver assembly with brackets.



5. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKETS (for Navigation Receiver Type)


    B296608
  1. Remove the 4 bolts.



    B352862
  1. Pull the navigation receiver assembly with brackets as shown in the illustration to detach the 6 claws on the backside of the navigation receiver assembly with brackets.

  1. Disconnect each connector to remove the navigation receiver assembly with brackets.



6. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    E199218
  1. Disconnect the connector.

  1. Detach the 2 claws to remove the hazard warning signal switch assembly.