Home › Vehicle Exterior › LIGHTING (EXT) › TURN SIGNAL FLASHER ASSEMBLY

TURN SIGNAL FLASHER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL TURN SIGNAL FLASHER ASSEMBLY
  1. Install the turn signal flasher assembly with the nut.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
  1. Connect each connector and hood lock control cable assembly.

  1. Attach the 13 clips and 2 guides to install the lower instrument panel finish panel sub-assembly.

  1. Install the 2 bolts <C>.

  1. Attach the 2 claws to close the cover.



3. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 7 clips to install the instrument cluster finish panel sub-assembly.



4. INSTALL NO. 2 SWITCH HOLE BASE
  1. Connect each connector.

  1. Attach the 6 clips and 2 guides to install the No. 2 switch hole base.



5. INSTALL COWL SIDE TRIM BOARD LH
  1. Attach the clip and claw to install the cowl side trim board LH.

  1. Install the clip.



6. INSTALL DOOR SCUFF PLATE ASSEMBLY LH
  1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate assembly LH.