Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL REAR COMBINATION LIGHT LENS AND BODY LH
  1. Attach the 2 clips and 3 guides to install the rear combination light lens and body LH.

  1. Install the 2 nuts.

    Torque:
    4.5 N*m{ 46 kgf*cm , 40 in.*lbf }

  1. Connect the connector.

  1. Install the cover.