Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE REAR COMBINATION LIGHT GASKET LH


    E280431
  1. Remove the rear combination light gasket LH.



2. REMOVE REAR TURN SIGNAL LIGHT BULB


    E280432
  1. Turn the socket in the direction indicated by the arrow to remove it.

  1. Remove the rear turn signal light bulb.



3. REMOVE BACK UP LIGHT BULB


    E280433
  1. Turn the socket in the direction indicated by the arrow and remove it.

  1. Remove the back up light bulb.



4. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE LH


    E280434
  1. Remove the screw.

  1. Detach the 3 clamps.

  1. Disconnect the connector and remove the rear combination light socket and wire LH.