Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > REASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE LH


    E280434
  1. Connect the connector.

  1. Attach the 3 clamps to install the rear combination light socket and wire LH.

  1. Install the screw.



2. INSTALL BACK UP LIGHT BULB


    E280436
  1. Install the back up light bulb.

  1. Turn the socket in the direction indicated by the arrow to install it.



3. INSTALL REAR TURN SIGNAL LIGHT BULB


    E280435
  1. Install the rear turn signal light bulb.

  1. Turn the socket in the direction indicated by the arrow to install it.



4. INSTALL REAR COMBINATION LIGHT GASKET LH


    E280431
  1. Install a new rear combination light gasket LH.