Home › Vehicle Exterior › LIGHTING (EXT) › HIGH MOUNTED STOP LIGHT ASSEMBLY

HIGH MOUNTED STOP LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT CENTER STOP LIGHT ASSEMBLY


    E136359E15
  1. Apply battery voltage to the connector and check the LED illumination condition.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2 (STP)
    Battery negative (-) → Terminal 1 (E)
    LED illuminates

    If the result is not as specified, replace the center stop light assembly.
    Text in Illustration 
    *a
    Component without harness connected
    (Center Stop Light Assembly)