Home › Vehicle Exterior › LIGHTING (EXT) › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE HEADLIGHT RELAY


    E280425
  1. Remove the headlight relay from the engine room relay box.



2. INSPECT HEADLIGHT RELAY


    A092673E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage not applied to terminals 1 and 2
    10 kΩ or higher
    Battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the headlight relay.



3. INSTALL HEADLIGHT RELAY
  1. Install the headlight relay to the engine room relay box.