Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR

AUTOMATIC LIGHT CONTROL SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK AUTOMATIC LIGHT CONTROL SENSOR


    E201558E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    G2-6 (CLTB) - G2-3 (CLTE)
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    G2-3 (CLTE) - Body ground
    Always
    Below 1 Ω

  1. Reconnect the G2 sensor connector.



    E162197E01
  1. Check the waveform of the G2 sensor connector.

    Waveform:
    Tester Connection
    Tool Setting
    Switch Condition
    Specified Condition
    G2-3 (CLTE) - G2-5 (CLTS)
    5 V/DIV., 5 msec./ DIV.
    Ignition switch ON, headlight dimmer switch AUTO
    Correct waveform is as shown

    HINT:
    If the ambient light becomes brighter, width A becomes narrower.
    If the result is not as specified, there may be a malfunction in the automatic light control sensor.

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Automatic Light Control Sensor)