Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD SWITCH

AUTOMATIC RUNNING BOARD SWITCH > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL SIDE AUTO STEP SWITCH ASSEMBLY
  1. Engage the 2 claws and install the side auto step switch assembly.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
  1. Connect each connector and hood lock control cable assembly.

  1. Attach the 13 clips and 2 guides to install the lower instrument panel finish panel sub-assembly.

  1. Install the 2 bolts <C>.

  1. Attach the 2 claws to close the cover.



3. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
  1. Attach the 5 clips to install the No. 1 instrument cluster finish panel garnish.



4. INSTALL COWL SIDE TRIM BOARD LH
  1. Attach the clip and claw to install the cowl side trim board LH.

  1. Install the clip.



5. INSTALL DOOR SCUFF PLATE ASSEMBLY LH
  1. Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate assembly LH.