Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › NAME PLATE

NAME PLATE > REMOVAL

for Preparation Click here


HINT:
When removing the symbol emblem, No. 1 back door emblem and No. 1 roof side mark, heat the vehicle body, symbol emblem, No. 1 back door emblem and No. 1 roof side mark using a heat light.

Standard:
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
Symbol Emblem
20 to 30°C (68 to 86°F)
No. 1 Back Door Emblem
20 to 30°C (68 to 86°F)
No. 1 Roof Side Mark
20 to 30°C (68 to 86°F)

NOTICE:
Do not heat the vehicle body, symbol emblem, No. 1 back door emblem or No. 1 roof side mark excessively.



1. REMOVE SYMBOL EMBLEM


B239323E02
  1. Put protective tape around the symbol emblem.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Wooden Block
    *3
    Boss
    *4
    Piano Wire

  1. Insert piano wire between the vehicle body and symbol emblem.

    HINT:
    Be careful of the boss positions.

  1. Tie objects that can serve as handles (for example, wooden blocks) to the piano wire ends.

  1. Pull the piano wire and scrape off the double-sided tape that holds the symbol emblem to the vehicle body.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Remove the symbol emblem.



2. REMOVE NO. 1 BACK DOOR EMBLEM


B239324E02
  1. Put protective tape around the No. 1 back door emblem.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Wooden Block
    *3
    Piano Wire

  1. Insert piano wire between the vehicle body and No. 1 back door emblem.

  1. Tie objects that can serve as handles (for example, wooden blocks) to the piano wire ends.

  1. Pull the piano wire and scrape off the double-sided tape that holds the No. 1 back door emblem to the vehicle body.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Remove the No. 1 back door emblem.



3. REMOVE NO. 1 ROOF SIDE MARK


B239326E02
  1. Put protective tape around the No. 1 roof side mark.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Wooden Block
    *3
    Piano Wire

  1. Insert piano wire between the vehicle body and No. 1 roof side mark.

  1. Tie objects that can serve as handles (for example, wooden blocks) to the piano wire ends.

  1. Pull the piano wire and scrape off the double-sided tape that holds the No. 1 roof side mark to the vehicle body.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Remove the No. 1 roof side mark.