Home › Vehicle Interior › LIGHTING (INT) › DOOR COURTESY LIGHT (for Front Door)

DOOR COURTESY LIGHT (for Front Door) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH


    B240255
  1. Detach the 2 clips to remove the front door lower frame bracket garnish LH.



2. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH


    B240700E01
  1. Using moulding remover, detach the 3 claws to remove the rear door inside handle bezel LH as shown in the illustration.
    Text in Illustration 
    *1
    Moulding Remover



3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH


    B240701
  1. Detach the 4 claws to remove the 2 door armrest caps.



    B240704
  1. Remove the 3 screws.

  1. Remove the 9 clips.



    B357470E01
  1. Pull out the rear door trim board sub-assembly LH in the direction indicated by the arrow as shown in the illustration.

  1. Raise the rear door trim board sub-assembly LH and detach the 4 claws and reference boss to remove the rear door trim board sub-assembly LH together with the rear door inner glass weatherstrip LH.
    Text in Illustration 
    *1
    Reference Boss



    B242772
  1. Disconnect the connector.



    B240708
  1. Disconnect the rear door lock remote control cable assembly LH and rear door inside locking cable assembly LH as shown in the illustration.



    B240710
  1. Using a screwdriver, detach the claw to remove the clamp.



4. REMOVE FRONT DOOR GLASS WEATHERSTRIP INNER LH


    B238526
  1. Using a screwdriver, detach the 4 claws to remove the front door inner glass weatherstrip LH from the front door trim board sub-assembly LH as shown in the illustration.



5. REMOVE COURTESY LIGHT ASSEMBLY


    E199239
  1. Detach the 2 claws and remove the light.

  1. Disconnect the connector.

  1. Remove the bulb.