Home › Vehicle Interior › LIGHTING (INT) › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSTALLATION

for Preparation Click here



1. INSTALL TRANSPONDER KEY AMPLIFIER


    E198068
  1. Connect the connector.

  1. Turn the key amplifier as shown in the illustration to attach the 2 claws and install the key amplifier.

  1. Install the cover with the screw.



2. INSTALL UPPER STEERING COLUMN COVER
  1. Attach the claw to install the steering column upper cover.

  1. Attach the 4 clips to install the steering column upper cover to the instrument cluster finish panel.



3. INSTALL LOWER STEERING COLUMN COVER
  1. Attach the 2 claws to install the steering column lower cover.

  1. Install the 2 screws.



4. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
  1. Attach the 7 clips to install the instrument cluster finish panel sub-assembly.



5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY
  1. w/o Smart Key System:

    1. Connect the cooler thermistor.

    2. Attach the 4 clips to install the lower instrument panel finish panel assembly.

  1. w/ Smart Key System:

    1. Connect the connector and cooler thermistor.

    2. Attach the 4 clips to install the lower instrument panel finish panel assembly.



6. INSTALL NO. 2 SWITCH HOLE BASE
  1. Connect each connector.

  1. Attach the 6 clips and 2 guides to install the No. 2 switch hole base.