Home › Vehicle Interior › LIGHTING (INT) › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > INSPECTION

for Preparation Click here



1. INSPECT TRANSPONDER KEY AMPLIFIER


    E074066E10
  1. Apply battery voltage to the connector and check the LED illumination.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 2 (ILL+)
    Battery negative (-) → Terminal 6 (ILL-)
    LED illuminates

    If the result is not as specified, replace the transponder key amplifier.
    Text in Illustration 
    *a
    Component without harness connected
    (Transponder Key Amplifier)