Home › Vehicle Interior › LIGHTING (INT) › IGNITION KEY CYLINDER LIGHT

IGNITION KEY CYLINDER LIGHT > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 SWITCH HOLE BASE


    B239275
  1. Detach the 6 clips and 2 guides.

  1. Disconnect each connector and remove the No. 2 switch hole base.



2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY


    B239279
  1. w/o Smart Key System:

    1. Detach the 4 clips.

    2. Disconnect the cooler thermistor and remove the lower instrument panel finish panel assembly.



    B239276
  1. w/ Smart Key System:

    1. Detach the 4 clips.

    2. Disconnect the connector and cooler thermistor and remove the lower instrument panel finish panel assembly.



3. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B354467
  1. Detach the 7 clips to remove the instrument cluster finish panel sub-assembly.



4. REMOVE LOWER STEERING COLUMN COVER


    C216494
  1. Remove the 2 screws.

  1. Detach the 2 claws to remove the steering column lower cover.



5. REMOVE UPPER STEERING COLUMN COVER


    C216495
  1. Detach the 4 clips.

  1. Detach the claw to remove the steering column upper cover.



6. REMOVE TRANSPONDER KEY AMPLIFIER


    E198066
  1. Remove the screw and cover.



    E198067
  1. Turn the key amplifier as shown in the illustration to detach the 2 claws and remove the key amplifier.

  1. Disconnect the connector.