Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT (for Front)

ROOM LIGHT (for Front) > INSPECTION

for Preparation Click here



1. INSPECT MAP LIGHT ASSEMBLY


    E198779E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    9 (+B1) - 1 (GND)
    Spot light switch off
    10 kΩ or higher
    Spot light switch on
    Below 1 Ω
    9 (+B1) - 6 (CTY)
    Not door position
    10 kΩ or higher
    Door position
    Below 1 Ω

  1. Apply battery voltage to the connector and check the LED illumination.

    OK:
    Condition
    Specified Condition
    Battery positive (+) → Terminal 8 (ILL+)
    Battery negative (-) → Terminal 10 (ILL-)
    LED illuminates

    Text in Illustration 
    *a
    Component without harness connected
    (Map Light Assembly)
    If the result is not as specified, replace the map light assembly.