Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/ Rear No. 2 Seat)
  1. Install the curtain shield airbag with the new 14 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

    NOTICE:
    Do not twist the curtain shield airbag when installing it.



    B242207
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



2. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH (w/o Rear No. 2 Seat)
  1. Install the curtain shield airbag with the new 11 bolts.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

    NOTICE:
    Do not twist the curtain shield airbag when installing it.



    B242207
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



3. INSTALL ROOF HEADLINING ASSEMBLY
  1. Install the roof headlining (Click here).