Home › Vehicle Interior › DOOR LOCK › TRANSMITTER BATTERY (w/o Smart Key System)

TRANSMITTER BATTERY (w/o Smart Key System) > REPLACEMENT

for Preparation Click here


NOTICE:
Take extra care when handling these precision electronic components.



1. REMOVE TRANSMITTER HOUSING COVER


    B225782E01
  1. Twist a screwdriver in the direction of the arrow in the illustration and remove the transmitter housing cover.

    NOTICE:
    Do not forcibly pry open the cover.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape



2. REMOVE DOOR CONTROL TRANSMITTER MODULE


    B137124E01
  1. Using a precision screwdriver, remove the door control transmitter module.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape



3. REMOVE TRANSMITTER BATTERY


    B102246
  1. Twist a coin in the direction of the arrow in the illustration and remove the transmitter battery cover.



    B102247
  1. Remove the battery (lithium battery: CR2016).

    NOTICE:
    1. Do not push the terminals with your finger.
    2. Do not forcibly pry up the battery. The terminals may become damaged.
    3. Do not touch the battery with wet hands. Water may cause rust.
    4. Do not touch or move any components inside the transmitter. The transmitter may cease to work.



4. INSTALL TRANSMITTER BATTERY


    B102768
  1. Install a new battery (lithium battery: CR2016) with the positive (+) side facing upward as shown in the illustration.

    NOTICE:
    1. Be careful not to bend the transmitter battery electrode during insertion.
    2. Keep the transmitter cover interior free of dust and oil.

  1. Install the cover.



5. INSTALL DOOR CONTROL TRANSMITTER MODULE
  1. Install the door control transmitter module.



6. INSTALL TRANSMITTER HOUSING COVER
  1. Install the transmitter housing cover to the transmitter housing case.

  1. Check that the transmitter LED illuminates 3 times when a switch is pressed 3 times.