AIR PUMP > ON-VEHICLE INSPECTION |
| 1. INSPECT AIR PUMP ASSEMBLY |
Start the engine and warm it up.
Turn the ignition switch off.
![]() |
Connect the 400 A probe of an ammeter to the positive (+) wire of the air pump assembly.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Utility / Secondary Air Injection Check / Manual Mode / AIR PUMP: ON, ASV1: OPEN, ASV2: OPEN.
Measure the current while the air pump assembly is operating.
| Condition | Specified Condition |
| 20°C (68°F) | 10 to 40 A |
Turn the ignition switch off.