Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › AUTOMATIC RUNNING BOARD SYSTEM

DTC    43    Hall Effect Sensor LH

DTC    44    Hall Effect Sensor RH

for Preparation Click here


DESCRIPTION

When the automatic running board is operating and the current in the side auto step motor is within standard parameters, the side auto step controller ECU assembly halts the operation of the automatic running board if it does not receive a side auto step motor hall sensor signal.

DTC No.
Detection Condition
Trouble Area
43
The side auto step motor LH current is normal and there is no side auto step motor assembly LH hall sensor signal.
  1. Wire harness or connector
  2. Side auto step motor assembly
44
The side auto step motor RH current is normal and there is no side auto step motor assembly RH hall sensor signal.

WIRING DIAGRAM


E237748E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (SIDE AUTO STEP MOTOR - SIDE AUTO STEP CONTROLLER ECU)
  1. Disconnect the O25*1 or N23*2 side auto step motor assembly connector.

    1. *1: for LH
    2. *2: for RH

  1. Disconnect the A41 side auto step controller ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    for LH:
    Tester Connection
    Condition
    Specified Condition
    O25-1 (-1) - A41-5 (SSR-)
    Always
    Below 1 Ω
    O25-2 (SSR1) - A41-10 (SSR1)
    Always
    Below 1 Ω
    O25-3 (+1) - A41-14 (SSR+)
    Always
    Below 1 Ω
    A41-10 (SSR1) - Body ground
    Always
    10 kΩ or higher
    for RH:
    Tester Connection
    Condition
    Specified Condition
    N23-1 (-2) - A41-5 (SSR-)
    Always
    Below 1 Ω
    N23-2 (SSR2) - A41-9 (SSR2)
    Always
    Below 1 Ω
    N23-3 (+2) - A41-14 (SSR+)
    Always
    Below 1 Ω
    A41-9 (SSR2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE SIDE AUTO STEP MOTOR ASSEMBLY