CRUISE CONTROL SYSTEM > ROAD TEST |
| INSPECT SET SWITCH |
![]() |
Turn the cruise control switch on.
Check that the cruise main indicator light in the combination meter assembly illuminates.
Drive the vehicle at a desired speed (between approximately 40 km/h and 200 km/h [25 mph and 125 mph]).
![]() |
Push the cruise control switch to -SET.
Check that the SET indicator light in the combination meter assembly illuminates.
After releasing the switch, check that the vehicle cruises at the desired speed.
| INSPECT "+" SWITCH |
![]() |
Turn the cruise control switch on.
Drive the vehicle at a desired speed (between approximately 40 km/h and 200 km/h [25 mph and 125 mph]).
![]() |
Push the cruise control switch to -SET.
![]() |
Check that the vehicle speed increases while the cruise control switch is pushed to +RES, and that the vehicle cruises at the set speed when the cruise control switch is released.
Momentarily push the cruise control switch upward to +RES and immediately release it. Check that the vehicle speed increases by about 1.6 km/h (1 mph) (tap-up function).
| INSPECT "-" SWITCH |
![]() |
Turn the cruise control switch on.
Drive the vehicle at a desired speed (between approximately 40 km/h and 200 km/h [25 mph and 125 mph]).
![]() |
Push the cruise control switch to -SET.
Check that the vehicle speed decreases while the cruise control switch is pushed down to -SET, and that the vehicle cruises at the set speed when the cruise control switch is released.
Momentarily push the cruise control switch downward to -SET and immediately release it. Check that the vehicle speed decreases by about 1.6 km/h (1 mph) (tap-down function).
| INSPECT CANCEL FUNCTION (CANCEL SWITCH) |
![]() |
Turn the cruise control switch on.
Drive the vehicle at a desired speed (between approximately 40 km/h and 200 km/h [25 mph and 125 mph]).
![]() |
Push the cruise control switch to -SET.
When performing one of the following, check that the cruise control system is canceled and that the normal driving mode is reset.
| INSPECT RES (RESUME) SWITCH |
![]() |
Turn the cruise control switch on.
Drive the vehicle at a desired speed (between approximately 40 km/h and 200 km/h [25 mph and 125 mph]).
![]() |
Push the cruise control switch to -SET.
Cancel the cruise control system by performing one of the following.
![]() |
![]() |
After the cruise control switch is pushed up to +RES at a driving speed of more than 40 km/h (25 mph), check that the vehicle restores the speed that was set before the cancellation.