Vehicle Condition
| Auto Cancel Condition
| Fail-safe Deactivation Condition
|
Cruise main indicator light blinks
| - There is an open or short in the stop light switch circuit
- There is a problem with the vehicle speed signal
- There is a problem with the throttle with motor body assembly
| Turn the cruise control switch on again
|
Cruise main indicator light blinks
| - There is a problem with the input circuit of the stop light switch circuit
- There is a problem with the cancel circuit
| - Turn the cruise control switch on again
- Turn the ignition switch off and then to ON again
|
Cruise main indicator light remains on (Cruise control is canceled)
| Under either of the following conditions, cruise control operation is canceled but the stored vehicle speed is maintained:
- The vehicle speed is less than the low speed limit (approximately 40 km/h [25 mph]) while driving with the cruise control system in operation
- The vehicle stability control system is operated
| Push the cruise control switch to +RES
|
Under the following condition, cruise control operation is canceled but the stored vehicle speed is maintained:
- The vehicle speed is less than the stored speed by approximately 16 km/h (10 mph) or more
| Push the cruise control switch to -SET
|