Home › Drivetrain ยท A750E AUTOMATIC TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE

TRANSMISSION CONTROL CABLE > REMOVAL

for Preparation Click here



1. REMOVE CONSOLE BOX ASSEMBLY
  1. Remove the console box assembly (Click here).



2. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Move the shift lever to N.



    C214423
  1. Disconnect the transmission control cable end from the shift lever.



    C214430
  1. Rotate the socket counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.

    NOTICE:
    Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.



    C214587
  1. Remove the nut and clip, and disconnect the transmission control cable assembly from the automatic transmission.

  1. Disconnect the end of the transmission control cable from the shift lever assembly.



    C129546
  1. Remove the 2 nuts and disconnect the transmission control cable support.



    C216997
  1. Remove the 2 nuts and detach the 3 claws, and then pull out the transmission control cable.