Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


    C099161E02
  1. Secure SST in a vise.

    SST
    09727-30021   (09727-00010, 09727-00031)
    09727-00060  



    C263591
  1. Attach the arm of SST to the diameter of the front coil spring.

    CAUTION:
    1. Make sure that the front coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
    2. Make sure that the claws of the hooks are securely attached.

  1. Using SST, compress the front coil spring.

    CAUTION:
    1. If the front coil spring bends during the compression, immediately stop the compression and reinstall SST.
    2. Do not compress the spring until the coil springs contact each other.
    3. Do not use an impact wrench. It will damage SST.



    C099162
  1. Confirm that the front coil spring becomes free and remove the front support to front shock absorber nut.

    CAUTION:
    Do not remove the front support to front shock absorber nut when the front coil spring is not free.



2. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH
  1. Remove the suspension support, cushion and 2 retainers from the shock absorber rod.



3. REMOVE FRONT COIL SPRING LH
  1. Remove the coil spring from the shock absorber.



4. REMOVE FRONT SHOCK ABSORBER BUSH


    C214442E01
  1. Using SST and a press, remove the absorber bush.

    SST
    09710-30012   (09710-04071, 09710-04081)