Home › Suspension › FRONT SUSPENSION › FRONT SHOCK ABSORBER

FRONT SHOCK ABSORBER > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT SHOCK ABSORBER BUSH


    C214442E01
  1. Using SST and a press, install a new absorber bush.

    SST
    09710-30012   (09710-04071, 09710-04081)



2. INSTALL FRONT COIL SPRING LH


    C159782E02
  1. Attach SST to the front coil spring and secure it in a vise.

    SST
    09727-30021   (09727-00010, 09727-00031)
    09727-00060  



    C263591
  1. Attach the arm of SST to the diameter of the front coil spring.

    CAUTION:
    1. Make sure that the front coil spring is installed so that the distance between the upper and lower hooks of SST is at the maximum.
    2. Make sure that the claws of the hooks are securely attached.

  1. Using SST, compress the front coil spring.

    CAUTION:
    1. If the front coil spring bends during the compression, immediately stop the compression and reinstall SST.
    2. Do not compress the spring until the coil springs contact each other.
    3. Do not use an impact wrench. It will damage SST.



    C155966E02
  1. Install the front coil spring onto the front shock absorber assembly.
    Text in Illustration 
    *a
    Lower End

    NOTICE:
    Make sure to fit the end of the spring that has the larger diameter into the front shock absorber lower seat.

    HINT:
    Fit the lower end of the front coil spring into the gap of the front shock absorber lower seat.



3. INSTALL FRONT SUSPENSION SUPPORT SUB-ASSEMBLY LH
  1. Install the cushion, 2 retainers and suspension support to the piston rod.

  1. Temporarily install a new front shock absorber nut to the suspension support.



    C214441E01
  1. Position the suspension support as shown in the illustration.
    Text in Illustration 
    *A
    LH
    *B
    RH
    *1
    Absorber Bush
    *2
    Suspension Support Sub-assembly
    V100135
    Front

  1. Remove SST.

    HINT:
    Release the coil spring while checking the position of the suspension support.

    NOTICE:
    Do not use an impact wrench. It will damage the shock absorber rod.



4. TIGHTEN FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT
  1. Tighten a new nut.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }