Home › Suspension › FRONT SUSPENSION › FRONT UPPER SUSPENSION ARM

FRONT UPPER SUSPENSION ARM > REASSEMBLY

for Preparation Click here



1. INSTALL FRONT UPPER BALL JOINT DUST COVER LH


    C159213E04
  1. Pack the upper arm ball joint with MP grease.

    Grease capacity:
    8.0 g (0.282 oz.)

    Text in Illustration 
    *1
    MP Grease

  1. Apply MP grease to the locations shown in the illustration.

    NOTICE:
    Do not apply MP grease to the tapered or threaded parts of the ball joint.

  1. Install the dust cover to the upper arm.



    C214806
  1. Using a snap ring expander, install the dust cover set ring.

    NOTICE:
    Make sure the set ring is securely installed in the groove.



2. INSTALL FRONT SUSPENSION UPPER ARM BUSH LH


    G020156E02
  1. Using SST and a press, press in a new bush.

    SST
    09710-26011   (09710-05061)

    HINT:
    Press in the rear side bush using the same procedure as for the front side.