Home › Suspension › FRONT SUSPENSION › FRONT LOWER SUSPENSION ARM

FRONT LOWER SUSPENSION ARM > REASSEMBLY

for Preparation Click here



1. INSTALL LOWER BALL JOINT DUST COVER LH
  1. Pack the lower arm ball joint with MP grease.

    Grease capacity:
    8.0 g (0.282 oz.)



    C214808E01
  1. Apply MP grease to the locations shown in the illustration.
    Text in Illustration 
    *1
    MP Grease

    NOTICE:
    Do not apply MP grease to the tapered or threaded parts of the ball joint.

  1. Install the dust cover to the lower arm.



    C214807
  1. Using a snap ring expander, install the dust cover set ring.

    NOTICE:
    Make sure the set ring is securely installed in the groove.



2. INSTALL FRONT NO. 2 LOWER ARM BUSH LH


    C214809E01
  1. Using SST and a press, press in a new bush.

    SST
    09387-00020  
    09710-30041   (09710-03221)
    Text in Illustration 
    *a
    Bush Positioning Protrusion

    NOTICE:
    Press in the bush while making sure the bush positioning protrusions are perpendicular to the lower arm as shown in the illustration.



3. INSTALL FRONT NO. 1 LOWER ARM BUSH LH


    C214810E01
  1. Using SST and a press, press in a new bush.

    SST
    09612-30012  
    09710-30012   (09710-04081)