Home › Vehicle Exterior › HORN › INTEGRATION RELAY

INTEGRATION RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE NO. 1 RELAY BLOCK COVER
  1. Remove the No. 1 relay block cover.



2. INSPECT NO. 1 INTEGRATION RELAY


    B236388E01
  1. Using a screwdriver, detach the 2 claws and disconnect the No. 1 integration relay from the engine room junction block.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape



    B216347E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1E-1 - 1C-8
    Battery voltage is not applied to terminals 1C-6 and 1C-7
    10 kΩ or higher
    1E-1 - 1C-8
    Battery voltage is applied to terminals 1C-6 and 1C-7
    Below 1 Ω

    If the result is not as specified, replace the No. 1 integration relay.
    Text in Illustration 
    *a
    Component with harness connected
    (No. 1 Integration Relay)

  1. Attach the 2 claws to install the No. 1 integration relay to the engine room junction block.



3. INSTALL NO. 1 RELAY BLOCK COVER
  1. Install the No. 1 relay block cover.