Home › Engine / Hybrid System › 1GR-FE INTAKE / EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE REAR ENGINE UNDER COVER ASSEMBLY
  1. Remove the 4 bolts and rear engine under cover assembly.



2. REMOVE REAR QUARTER PANEL MUDGUARD RH (w/o Intuitive Parking Assist System)
  1. Remove the 3 clips, 6 screws and rear quarter panel mudguard RH.



3. REMOVE REAR QUARTER PANEL MUDGUARD RH (w/ Intuitive Parking Assist System)
  1. Remove the 4 clips, 4 screws and rear quarter panel mudguard RH.



4. REMOVE REAR BUMPER SIDE BRACKET RH (w/o Intuitive Parking Assist System)


    A313866E01
  1. Remove the clip and 3 screws.
    Text in Illustration 
    *1
    Guide

  1. Detach the guide and remove the rear bumper side bracket RH.



5. REMOVE REAR BUMPER SIDE BRACKET RH (w/ Intuitive Parking Assist System)


    A224825E01
  1. Remove the clip and 3 screws.
    Text in Illustration 
    *1
    Guide

  1. Detach the guide and remove the rear bumper side bracket RH.



6. REMOVE TAILPIPE ASSEMBLY
  1. Remove the 2 bolts and disconnect the tailpipe assembly from the exhaust pipe support.

  1. Remove the gasket and exhaust pipe support.



7. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts and 2 compression springs, and then disconnect the center exhaust pipe assembly from the 4 exhaust pipe supports.

  1. Remove the gasket and 4 exhaust pipe supports.



8. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 2 bolts, 2 nuts and front exhaust pipe assembly.

  1. Remove the gasket.



9. REMOVE EXHAUST PIPE STOPPER BRACKET (for 4WD)
  1. Remove the 2 bolts and exhaust pipe stopper bracket.



10. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 2 nuts and disconnect the front No. 2 exhaust pipe assembly from the exhaust pipe support.

  1. Remove the 2 gaskets and exhaust pipe support.



11. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
  1. Disconnect the sensor connector.



    A223687E01
  1. Using SST, remove the sensor.

    SST
    09224-00010  



12. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A223689E01
  1. Using SST, remove the sensor.

    SST
    09224-00010